ECU programmer for UPA with EEPROM adapters & diagnostic tool1、Full Adapters Set: The main device can be directly connected to the UPA USB Serial Programmer or by an optional DB9 male female 1:1 extension cable. It's equipped with an 40pin ZIF Socket for all narrow and wide DIP DIL devices as well as with a 16 pin SOIC ZIF (150mil, narrow) socket to cover most commonly used devices. 2、Easy to Operate: Device configuration is done over special config keys which make the work convenient and safe compared to wiring up all manually. Additional packages can be covered by commonly available adapters plugged into the 40 pin ZIF socket. 3、ISP Connector: The main device further includes a 10 pin ISP connector where the included ISP Adapters can be connected using a standard 1:1 flatribbon cable (included). The included PLCC ISP Adapters are to be put directly over the soldered chip of the target device making the work convenient and safe compared to soldering or using clips connecting up all manually. 4、EEPROM: Simply connect the mainboard to the UPA programmer directly or by using a DB9 male female extension cable (1:1). Insert the correct config key into the slot of the mainboard and start programming either via the ZIF or SOIC Socket. 5、For MCU: Pick the adapter you want to use, attach the flat cable to the adapter (PIN1 is always indicated, on both the cable and also the Adapter) and also to the main board's 10pin ISP connector. Select the VCC supply source by the jumper on the mainboard next to the ISP connector (on: target supplied from upa, off: target got own supply). Slide the Adapter over the soldered PLCC MCU on the target PCB.