and High QualityThis valve is the replacement of the float ballcock, which can be applied to of high water tanks, pools, water towers of the industry and civil construction, etc.Automatic control, low self-complementary water, water full automatic stop.Four intakes, volume of waterBeautiful appearance, small size, practical, simple installation.Without electricity, easy to use, , low failure rate, saving water resourcesWhen the pool or tank water levels fall, the valve body will sink down and then the forerunner of the control valve will be opened. As the pipe water pressure affects, the seal face of control valve will be opened. Finally the water comes out and Specifications:Type: Inner InstallationWorking pressure range: 1-10KG(0.1-1MPa)Applicable Medium: clean waterApplicable Medium temperature: less than 70Resistance to high temperature medium temperature: 70~120Outlet Diameter: G1/2Size: 100.2x58x50mm: 1 Pccolor: Whitematerial: plasticPackage Contents:1*Water level control valveNote:This production belongs to the liquid level control valves. When installed, the float must be vertical. if you need to install from the top , a Elbow needed to connect the float valve and the inlet line. , the feed line should be fixed in horizontal plane and then connect the automatic water level control valve on the water inlet according to the standard. The main water inlet should be lined with the control valves' Normal Diameter. When using, the globe valve should be all open. If two valves are installed in the same pool, the two valves should be in the same horizontal plane. installing, clean the impurities in the pipes in case of blocking.If the water quality is not good, then the valves need to be maintained properly.If the users find the time of adding water becomes , he can just upload the water inlet and washedOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.