Features: Ultra silent Scanning Design, two different shaft length quartz movement for your choice. Sweep clock movemen without any noise which can offer your sleep a silent environment. Suitable for DIY quartz wall clocks, wooden wall clocks, metal wall clocks, craft clocks, frameless wall clocks, etc., to replace broken clocks, etc. DIY Wall Clock Repair Parts Kits. Easy for installation,Multiple choices in one set. Clock Hands Size:The size indicated in the picture shall prevail, they were made of aluminum, please do not install them with too much pressure or they will be bent, please check the sizes before buyi Wide Application. DIY quartz wall clock replacement movement parts. Good handwork material to make a clock by yourself. Specifications: Material: Plastic, Brass, Aluminum Color: Black Pointer Size: the total round hole is measured to the end of the needle, Hour Hand: 82/70.5mm(3.15x2.78in), Minute Hand 117/101mm(4.61x3.98in). Weight:Approx. 180g Power: 1.5 V AA 1 Piece Battery (not included) Package Includes: 2 Pieces Quartz Alock Movements 5 Pieces Minute Hands 5 Pieces Hour Hands 4 Pieces Second Hands 2 Pieces Second Cap Nuts 2 Pieces Rubber Gaskets 2 Pieces Brass Washers 2 Pieces Brass Hex Nuts 2 Pieces Metal Hooks note: 1.Please allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid. 2.Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you! 3.The hour and minute hands have a protective plastic coating that needs to be carefully removed. 4.Be careful not to bend the hands with too much pressure. 5.Please do not use alkaline battery, rechargeable battery, or they will damage the movement. 6.Do not tighten the brass hex nut too tight. 7.Press hard to get all clock hands in place. 8.Check if all hands are aligned.