Item Type: Voltage Signal Generator Input Voltage: Default DC15-30V Input Current and Power Consumption: Minimum Standby Current: 40MA / 24V Maximum Allowable Working Current: 200MA / 24V Maximum Allowable Surge Peak Current: 1A Allowable Input Power Ripple: 500MV Analog Signal Output Voltage Accuracy: 1% Analog Voltage Output Signal Load Capacity: 50MA Output Short-circuit Protection Allowable Time: 3 seconds Short Circuit Protection Recovery Method: Automatic recovery Analog Signal Output Voltage Ripple: 30MV Cooling Method: Natural cooling (normal working temperature does not exceed 65 degrees) Use Occasion: Can not be placed next to other heating equipment, to avoid dust, oil mist, corrosive gases, excessive humidity and strong vibration. No flammable gas, conductive dust or liquid Working Temperature: -15 ~ + 45 Operating Humidity: 40% ~ 90% Permissible Vibration: Less than 10-55HZ / 0.15MM Storage Temperature: -20 ~ + 65 Space Interference Radio Waves: No requirements1The product can output 0-10V voltage 2Can work independently and can be used with PLC, industrial control board, or various motion control cards, industrial control controllers, which has strong compatibility 3With fully enclosed enclosure, strong protection 4Mounting and fixing method according to standard industry 5135 5The wiring uses 5. 08mm 4-bit terminal blocks, easy to wire and maintain 6Automatic range intelligent switching display, below 10V, 2 digits after the decimal point, and above 10V, 1 digit after the decimal point 1 xVoltage Signal Generator