Automatic Start-Stop Button Start-Stop Switch Device For Nissan For X-trail T32 2014- For Qashqai J11 2015- 2017 For 2015 Bluebird- For 2015 Murano- For Serena c26 2010-2016 For Serena c27 Size: 23*30mm Packing: 1 * Start Stop Button, 1 * Manual, 1 * Tool Instructions for Use: 1. After starting the vehicle for 5 seconds, the start-stop function is automatically disabled. Effectively improve battery life and spark plugs 2. The start-stop switch is the same as the original car, which can be switched off or on at will without affecting the use of the original car 3 function. Memory function: before each power off, the start-stop on/off status is automatically memorized and saved; The next time the car is started, the start-stop status before the last flame is automatically restored. Note: 1. There are more than 10 seconds between flame and restart, otherwise start and stop will not be automatically closed this time 2. After installing the start-stop shutter, turn off the vehicle after starting the vehicle, wait 20 seconds to restart the car d to activate the start-stop shutter Solve the problem: 1. Frequent loss of cranking Traffic/waiting for red light, serious engine loss 2. Loss of motor and battery starting Frequent shaking affects driving and serious battery loss 3. Increase oil cost High level of oil drainage quality requirements during the engine start and stop process increase the cost of vehicle use 4. Damage to the electrical system in the car Frequent starting often affects the electrical system precision in the car Features: 1. Protect the engine Effectively prevent engine damage caused by frequent starting 2. Protect the battery Effectively prevent damage to the battery due to frequent starting and prolong its service life 3. Reduce fuel consumption Reduce vehicle costs 4. Smart Chip Stable with dual-core terminal chip 5. Protect the spark plug Effectively prevent the loss caused by frequent starting when traffic jams and other red lights 6. Match Material Precision Manufacturing, Fit Vehicle Interface 7. Non-destructive Plug and play installation, direct installation without broken wires in 8. Default closed The start-stop function of the original car is automatically closed when the vehicle is started, and there is no need to manually close it after installation 9. New update Button start and stop version, more convenient and convenient to use Installation steps: 1. Use rocker to pry up the door panel 2. Remove the two screws of the fuel tank switch 3. Remove the fuel tank switch, you need to unscrew the screw inside 4. Use the swingarm to pry up the trim under the handlebars 5. Pull out the plug of the start-stop switch 6. Remove the three screws into the decorative plate 7. Fastened buckle with open stop 8. Take out the original car d and button to start and stop 9. The original car start-stop plug and the start-stop button are matched to each other 10. Put the disassembled parts back in place