Feature: 1. Double Sided Coating: The steel plate is double sided coating, one side is gold powder, the other side is smooth PEI, and has both smooth and powder sides. 1 steel plate can meet 2 printing requirements. 2. Easy to Use: This double sided coated bed sheet is very easy to use, just put on your heating bed, and both sides can be used directly. 3. Basic Specifications: This is steel plate with a size of 355 x 355mm, which is suitable for construction boards of the same size. 4. Spring Steel: The flexible steel plate is made of high quality spring steel, which will not kink or warp when you bend slightly, easy to adhere to the printed surface and easy to remove the printed matter. 5. Bending the Plate: When the temperature of the heating bed reaches room temperature, the prints will easily fall off the surface. If the print is still jammed, bending the plate slightly will help remove. Specification: Item Type: Spring Steel Sheet Material: Steel Colour: Golden Size: Approx. 355 x 355mm / 14.00 x 14.00in Applicable Machine: for Voron 350 V2 Print Reference Temperature 1.PLA: (Both sides are fine) Hot Bed: 50-60℃ Nozzle: 200-210℃ Hot Bed 60℃, Nozzle 210℃ 2. ABS (Powder surface is recommended. After the temperature of the smooth surface exceeds 80℃, the surface is easy to foam) Hot Bed: 70-120℃ Nozzle: 240-250℃ 3. PETG: (Both sides are fine) Hot Bed: 60-85℃ Nozzle: 230-245℃ 4. Carbon Fiber (Both sides are fine, very close to PLA, hardened steel is recommended for the nozzle) Hot Bed: 50-60℃ Nozzle: 200-220℃ 5. TPU: (Both sides are fine) Hot Bed: 50-60℃ Nozzle: 200-220℃ Hot Bed 60℃, Nozzle 220℃ 6. Wood (Both sides are fine, very close to PLA) Hot Bed: 50-60℃ Nozzle: 200-220℃. Package List: 1 x Steel Plate Note: 1. The steel plate belongs to the elastic steel plate, and the printing plate needs to be flat when used, and the magnetic attraction is strong, and the steel plate can be firmly adsorbed on the plate.2. The first layer sprinklers should not scratch the platform, otherwise the sprinklers will scratch the platform and wear out the sprinklers.3. When printing the first layer, the nozzle should not be too far away from the platform, otherwise will not stick to the printing platform, and the gaps between the nozzle and the steel plate should be about a piece of A4 paper.4. The model cooling fan cannot be turned on for the first layer printing, otherwise will affect the adhesion of the first layer printing.5. Add a skirt when printing a model with a small contact surface.