1. Automatically charges the battery. 2. The rectifier and brake circuit of this controller uses an integrated module, offering improved heat dissipation and reliability compared to traditional designs. 3. Features a fully sealed, waterproof design with an IP67 protection rating, allowing for long-term normal operation even when submerged in water. Note: Ensure the output voltage of the wind turbine generator matches the rated voltage of the battery. Connect the wires in the following order: first connect the batterys positive and negative terminals, then connect the three-phase output of the wind turbine. Always connect the battery and wind turbine to the controller according to the instructions. Reversed polarity or incorrect connections may cause system malfunction or permanent damage to the controller. Wiring instructions: 1. Connect the batterys positive and negative terminals to the controllers battery positive (red) and negative (black) terminals. 2. Connect the wind turbines three-phase output to the controllers three-phase input (green wires). Specifications: 1. Maximum input AC voltage: AC35V 2. Output voltage: 12V / 24V 3. Battery charging cut-off voltage: 14.5V 0.3V / 29V 0.3V 4. Maximum charging current: 15A (12V), 10A (24V) 5. Wind generator speed limit voltage: 14.5V 0.3V / 29V 0.3V 6. Protection level: IP67 7. Static power consumption: 0.008A 8. Rated power: 800W 9. Maximum allowable wind speed: 12 m/s 10. Operating temperature: -35C to 65C 11. Input wiring: Three-wire system 12. Control mode: Compatible with 12V/24V systems 13. Installation: Bolted 14. Do not reverse the positive and negative terminals to prevent damage to the controller. Application: Wind charge controller Color: Blue Material: Aluminum alloy Package includes: 1 x MPPT Wind Generator Controller Note: Light reflection and display differences may cause slight variations in color between the image and the actual item. Measurement may vary by 1-3cm.